Machsupport Forum
Third party software and hardware support forums. => SmoothStepper USB => Topic started by: cam4ge on April 09, 2013, 12:03:41 AM
-
I was wondering who has done this setup before i would like to find a resource for some problem solving.leave me a pm. i am frustrated with it and it would help to have someone to drop a line to. thanks immensely - Andy
-
If you can describe the problem you are having and what you have done to try and solve it you will get more responses.
-
right now i keep getting an e4or about jd write code? i am headed to my shop in a ibit but i c+ot find what this means. any ideas. thanks
-
I have no idea what you just wrote. Can you please be more clear?
-
what i meant to write is that the dumba! that wired between ess and main board screwed up one of the co+ection (hooking up a wire so it l9ked like an esher paintin .now that i have redone those 2 wires i wi? give it a go in the morning. lol when a? else fails.....in everything.back to fundementals! lol i wi? report back.thank you Je#.
-
I don't know if it is a language barrier or a typing barrier but your messages are almost impossible to decipher. I would really like to help but I cant make sense out of your message.
-
I don't need to try and type from my phone. sorry Jeff. one problem i found was wiring between the ss and the board. i double checked everything and there are more lights on ( thats good i think) now i just realized that i have 2 ports with the ss and the instructions i have are for 1 port. i try and run the configurator (in bootp mode) and it is not getting a response however when i ping it it gets back all of the packets. i just don't know enough to figure out how to configure. when i run the test button i get movement which leads me to believe it is somewhere either in software (and configuring which i know is part of it.) i just would like someone to help point me on how to setup for 2 ports and start to move in the right direction. Thank you Jeff and sorry about the garbled message !!-Andy
-
also the message i get is JT Write the server is not running.........
-
Please take a look at the new ESS manual: http://warp9td.com/files/ESS%20User's%20Manual%20Rev%200.1.pdf.zip
You do not need to run the configurator unless you need to change the IP address of the ESS. It comes already programmed as 10.9.9.9. Most problems folks encounter have to do with firewall programs. You must let Mach3 through your firewall, and of course have your PCs network adapter configured properly. It does not matter if you are using one or two ports on the ESS the configuration to get it to talk to mach3 is the same.
-
Cool Thanks Jeff that was actually a ton of help. the FT error was telling me that i did not have a ftp server set up on this computer and it turned out to be a firewall problem. I'll keep you posted.....Thanks a lot-CAM
-
Jeff,
the machine has movement in test mode. mach 3 shows movement, but no table movement. with my limited knowledge I am trying to figure out how to configure a pmdx-126 board properly for my Ethernenet smooth stepper. any advise to point me in that direction would help greatly. I have read what i have found on it but have not figured it out at this point. Thanks for your help!
Andy
-
There are only a few jumpers on the ESS and PMDX-126 that you need to mess with if you are wanting to power the ESS form the PMDX-126 or vise versa. The PMDX-126 manual covers this in great detail.