Machsupport Forum

Mach Discussion => VB and the development of wizards => Topic started by: Sparc on March 15, 2013, 07:46:14 AM

Title: Different Use of Anti-Dive Function
Post by: Sparc on March 15, 2013, 07:46:14 AM

Hi;

We are planning to make our own plasma table. We will use the Hypertherm Sensor PHC.

The target is to use the internal anti-dive function of mach3.
But this function diables only the Z-Axis movement.

How we can modify the function so we can have a signal on a given output port if the movement speed goes below the percentage given in OEMCODE 82?

Or must we have a special script for this.

Any idea will be very helpful. Best Regards in advance.

Selim

Title: Re: Different Use of Anti-Dive Function
Post by: BR549 on March 15, 2013, 08:23:30 PM

You would need to route the LED for antidive to an output by using a simple brain. That way when the Antidive turns ON it creates and ouput signal to hook to your PHC unit.