Machsupport Forum

Mach Discussion => Mach Screens => Topic started by: bf4cm28 on March 05, 2013, 12:55:55 AM

Title: 23" monitor
Post by: bf4cm28 on March 05, 2013, 12:55:55 AM

I recently upgraded to a 23" monitor  and can not figure out how to get Mach 3 to fill the screen!! Any ideas I have tried everything I can think of I am running a plasma cutter only

Title: Re: 23" monitor
Post by: Dan13 on March 05, 2013, 01:30:06 AM

Under General Config -> Screen Control tick the Auto Screen Enlarge option.

Dan

Title: Re: 23" monitor
Post by: bf4cm28 on March 05, 2013, 06:10:06 AM

Quote from: Dan13 on March 05, 2013, 01:30:06 AM

Under General Config -> Screen Control tick the Auto Screen Enlarge option.

Dan

Tried that

Title: Re: 23" monitor
Post by: Kenneth on March 05, 2013, 09:07:18 AM

i found that if i go to machscreen and open the set file. resetting the res(Frame Size) to 1600x950.
the default screen fills my screen. may have to adjust to fit your screen

Title: Re: 23" monitor
Post by: ger21 on March 05, 2013, 11:50:09 AM

Quote from: bf4cm28 on March 05, 2013, 06:10:06 AM

Quote from: Dan13 on March 05, 2013, 01:30:06 AM

Under General Config -> Screen Control tick the Auto Screen Enlarge option.

Dan

Tried that

You have tro close and restart Mach3 for it to take effect.

Title: Re: 23" monitor
Post by: Dan13 on March 05, 2013, 01:39:15 PM

Yes. Either that or reloading the screen in Mach3.

Dan

Title: 23" monitor
Post by: BasHIDAP on April 07, 2013, 10:23:57 AM

I updated to the newest Mach3 version and the same happened. No full size on the screen.

Title: Re: 23" monitor
Post by: Chaoticone on April 07, 2013, 11:21:29 AM

In general config., do you have the high res screen tick box ticked?  Do other applications fill the screen?  Could it be your monitor needs adjusting?

Brett

Title: 23" monitor
Post by: BasHIDAP on April 09, 2013, 11:55:15 AM

Tanks, that worked!!