Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Nixie on December 28, 2012, 04:06:09 PM

Title: regulating pwm spindle
Post by: Nixie on December 28, 2012, 04:06:09 PM

Hello everyone I'm Italian and I'm starting to use Mach3.
  Installation ok, calibration axes too.
The only setting that I can not do is adjust in pwm spindle.
I think I have everything set right but when I press iltasto "spindle cw" the spindle begins to rotate at low speed but when you press + or minus keys to adjust the RPM spindle speed increases up to the maximum and there is no possibility of adjustment.
Can someone tell me where I went wrong?
thanks

Title: Re: regulating pwm spindle
Post by: cncalex on December 29, 2012, 05:43:30 PM

Hi Nixie,
in members docs section you find the topic  "spindle speed control"
within that a pdf file that may help you.
btw thanks to GhrisJ for posting it. Was a great help for me.
Alex

Title: Re: regulating pwm spindle
Post by: Nixie on December 30, 2012, 11:23:45 AM

Thanks