Machsupport Forum
G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: dar6x on December 13, 2012, 01:13:18 PM
-
Hi All,
Can anyone tell me if there is a way to adjust the point where the drill switches from rapid to feed during each peck in a G83 cycle? It seems the default is 0.01" but I can't find any way to change this. I saw one other thread where somebody mentioned this but I couldn't find an answer. I want to decrease this value because I'm drilling through crystalline silicon with a diamond plated bit and my peck depth has to be <0.001" so with D=.01" less than 10% of the time is spent actually removing material. I'd like to speed this up.
thanks!!! BTW i'm using a TAIG with a DSLS 3000 controller from Microproto.
-David
-
Look in Config Ports/pins Mill options Look for G73 pull back
Not really sure if that is what you are lookng for. BUT try it.
(;-) TP