Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: Telad on December 06, 2012, 03:26:37 PM

Title: Units/Min Issues
Post by: Telad on December 06, 2012, 03:26:37 PM

Hello,

My CNC machine is working correctly and cutting out my part to spec; however the display for units/min seems to be 2x the actual speed. 

See attached.  Any ideas?  I asked in the general support and Hood suggested I try here.

I'm using the latest "lock down" demo version (soon to be licensed).

Title: Re: Units/Min Issues
Post by: NeoTO on December 07, 2012, 12:12:08 AM

We will take a look at this, but may take a while.

Title: Re: Units/Min Issues
Post by: Telad on December 07, 2012, 10:10:08 AM

So I take it in your system it displays the same?  In other words is this a known issue?

Title: Re: Units/Min Issues
Post by: NeoTO on December 07, 2012, 01:57:58 PM

Mach3 with stepper motors works in the open-loop control and controls the feedrate in advance. I am not aware on how the units/min is calculated and can not advise you here until we contact Mach3 authors.

Title: Re: Units/Min Issues
Post by: Telad on December 18, 2012, 11:43:32 PM

Any update on this issue?

Title: Re: Units/Min Issues
Post by: NeoTO on December 21, 2012, 04:16:39 AM

Still waiting for an answer from Brian...

Title: Re: Units/Min Issues
Post by: CoyDog on April 05, 2015, 05:17:11 AM

Is there an answer to this issue ??? after 3yr ?

Title: Re: Units/Min Issues
Post by: NeoTO on April 26, 2015, 02:00:58 AM

Have you tried the latest plugin? Quite a few versions back, the speed filtering has been applied.