Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: g8kmh on November 12, 2012, 05:48:41 PM

Title: Pokeys56 Pulse Engine and 4th Axis
Post by: g8kmh on November 12, 2012, 05:48:41 PM

If using the Pulse Engine for X, Y, Z, are there any recommended pins for step/dir for the A Axis?

Will an MPG drive the A axis via Mach3, bypassing the Pulse Engine on that axis?

Regards,
Lehane

Title: Re: Pokeys56 Pulse Engine and 4th Axis
Post by: NeoTO on November 15, 2012, 04:39:03 AM

Hi, Lehane

PoKeys supports only 3-axes at the moment and you can not assign additional pins for 'A' axis. The solution (pulse engine upgrade) is coming soon.

Title: Re: Pokeys56 Pulse Engine and 4th Axis
Post by: g8kmh on November 15, 2012, 05:39:11 PM

OK,
I'll look forward to that and leave the A axis until later. Let me know if you want an beta tester.

Regards,
Lehane