Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: eskay on October 15, 2012, 09:32:52 PM

Title: Controller Frequency Setting
Post by: eskay on October 15, 2012, 09:32:52 PM

Just getting started and noticed a problerm.... while in MDI and dumping in coordinates and the wait time for actuation to begin is 1min+ followed by an error code about SS frequency being too high for computer to understand.   Message recommends lowering to 1khz or 500 mhz.   I lowered it al the way to 250 and got long waits and proper motion, anything higher and error messages......

What's reasonable response time?

Thanks

S

Title: Re: Controller Frequency Setting
Post by: Hood on October 16, 2012, 02:56:47 AM

It should be immediate, suggest you contact Greg and see if he can shed any light on it.
Hood

Title: Re: Controller Frequency Setting
Post by: eskay on October 16, 2012, 06:46:37 AM

Will do, Thanks Hood