Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: softselect on September 28, 2012, 04:03:09 PM
-
OEM Button 186, Select Y axis for MPG1 not working
I have the pokeys USB ,the latest version of pokeys plugin (downloaded - 11/8/2012) and mach V062
i want to use pokeys for a mpg, select axis oembutton185 works, so does 187,188
if i load pokeys software the port(19) does toggle when i push the button
i created a screen with oem button 186, clicking it with the mouse, does switch to MPG y axis, so its not mach
any ideas
thanks Friedrich
-
Hi, Friedrich
Please download the latest PoKeys beta software, which includes the latest Mach3 plugin. We tested it on our machine and it works as intended.
Regards,
Matevž
-
Hi NeoTO,
I loaded the beta SW, but the problem remained, BUT i found the problem, on my pokeys pin 13 remains lo and does not change state, so i programmed pin 19 for selecting MPG Y axis, how ever even with pin 13 selected as "not used" it would keep mach from seeing button 186 being pressed, i reprogrammed pin 13 to a different button and made the the pin not used, then it all works fine
So you need to look at your plugin when a pin is programmed as not used, to automatically program it to "none" and not to hold the previous programmed function
In conclusion , before a pin is programmed to "not used" set the function to "none"
Thanks Friedrich
-
Hi, Friedrich
We will make sure that disabling the button in the settings really disables it. It should already...
Which PoKeys device are you using? PoKeys55?
Regards,
Matevž
-
hi NeoTO,
Yes i am using an old USB pokeys55 serial 10218, loaded with the latest firmware
Thanks Friedrich