Machsupport Forum
G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: Kai on September 26, 2012, 07:56:53 PM
-
I have been looking at hsm for a little while and it looks nice. Has anyone tried it with mach and what were you thooughts on it and does the post work ok with mach
-
Oh come on please somone out there must use this set up let us know what you think and what your post is like .
-
I haven't used it with MACH3 yet but it works fine using their Haas post processor.
You can download HSMXpress for free so why not give it a try.