Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: momechanik on September 26, 2012, 06:44:48 AM

Title: Problem with pot and feed rate override
Post by: momechanik on September 26, 2012, 06:44:48 AM

Hello,

I'm using a pot for feed override at pin 45. With the new plugin (Pokeys.dll 946176Bytes, 11.8.2012) the FRO display (DRO 821: Feedrate Override FRO) is only flickering from zero to the set value. If i choose another DRO, e.g. DRO 818: Feedrate, it works absolutely fine. I have tried it at 2 different computers with the same result.
With a formerly plugin(10.6.4), it also works good, but of course i want to use the new comfortable plugin.

My Mach3 Version is  ..66 and also Pokeys Beta v3.0.39 is installed.

Many thanks for Your help
Martin

Title: Re: Problem with pot and feed rate override
Post by: NeoTO on September 26, 2012, 06:49:04 AM

Hi, Martin

We will look into this problem. Apparently, Mach3 keeps overwriting this DRO.

Regards,
Matevž