Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: Holzwurm56 on September 18, 2012, 01:36:42 AM

Title: Question about limit and homing switches
Post by: Holzwurm56 on September 18, 2012, 01:36:42 AM

Hi ,
I am using pokeys 56u . My router has no extra home switch but end switches . It's possible like the Mach3 printerport mode to connect all endswitches
in one line and in reference drive mach3 recognice the endswitch as homeswitch and in working/milling mach3 uses the endswitches as endswitches ?

Many thanks for every answer

Hans

Title: Re: Question about limit and homing switches
Post by: NeoTO on September 18, 2012, 01:39:40 AM

At the moment, this is not possible. If there will be more requests, we will add this feature.

Regards,
Matevž