Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Bob La Londe on July 28, 2012, 01:22:30 PM

Title: Version 4
Post by: Bob La Londe on July 28, 2012, 01:22:30 PM

How is the progress coming on Mach 3 Version 4? 

Title: Re: Version 4
Post by: Wallerawang on August 02, 2012, 05:14:56 PM

A lot of us are wondering about this!
Steve

Title: Re: Version 4
Post by: klmark on August 02, 2012, 05:44:16 PM

Yes we do

Title: Re: Version 4
Post by: Bob La Londe on August 05, 2012, 01:21:59 PM

Mach4 pre-Alpha Testing
http://www.machsupport.com/forum/index.php/board,90.0.html

Found this.  Didn't realize boards had been added so didn't look.  Last Comment July 14th.

Title: Re: Version 4
Post by: Bob La Londe on October 13, 2012, 01:20:43 PM

I was just looking over the new Keling website and I noticed he is offering something I found kind of odd. 

Mach4-Lite Licensed Software with Ethernet Smoothboard with screw terminals
http://www.automationtechnologiesinc.com/products-page/cnc-cam-software/mach4-lite-software-with-ethernet-smoothboard-with-screw-terminals

The wording sounds odd...  and there are no manuals available... 

Title: Re: Version 4
Post by: Snipes44 on October 13, 2012, 01:31:21 PM

Check this link for Mach4 information.

http://www.machsupport.com/forum/index.php/topic,22539.0.html

Title: Re: Version 4
Post by: Bob La Londe on October 13, 2012, 01:39:30 PM

Or better yet... http://www.machsupport.com/comparison.php
Thank you.