Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Fred_evans on July 27, 2012, 10:39:30 AM

Title: cad/cam for a newbie wizard liscence??
Post by: Fred_evans on July 27, 2012, 10:39:30 AM

A search of the forum dug up a topic which contained the remark below.

"For starters you may consider just using the wizards in Mach3 mill. Better yet, pay the $50 for the Newfangled Solutions wizards license and you will be able to do most machining jobs without the need for CAD/CAM software at all. This conversational programing is a good way to go I think."

excuse my ignorance - but what is this all about?  the wizards liscence bit and what is conversational programming?

regards

fred

Title: Re: cad/cam for a newbie wizard liscence??
Post by: RICH on July 28, 2012, 08:20:01 AM

NFS is a  software package which is made up of a number of Wizards. Each wizard provides for a machining task. You purchase the software since it's
a Mach addon and thus a specific license is required.
RICH