Machsupport Forum
G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: FlatCreek on July 15, 2012, 03:21:01 PM
-
Having problem with Mach 3 showing my drawings massive when the are the correct size on SheetCam. Have one that is 12" x 12" but when Gcode is loaded into Mach3 it shows it as 355" x 355". Found in SheetCam where I needed to swap from metric to inch, did that but still the same problem. Also can seem to speed up x' & z. Goes very slow.
Or is there any place I can read or see a diagram on how to change this.
Thanks for any Help!!!