Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Aeroshade on June 02, 2012, 11:27:10 AM

Title: CV Mode turns off by its self
Post by: Aeroshade on June 02, 2012, 11:27:10 AM

Hello all, I have a problem with my CV Mode turning off on its own and I can't get it back on unless I relaunch Mach3. Not sure why it does this. It's not a big problem, just pauses around arcs.


Any help would be great :)

P.S. It's not in the program, since I can run the same program for days, then all of a sudden it does it (turns CV Mode off).

Title: Re: CV Mode turns off by its self
Post by: BR549 on June 02, 2012, 06:32:49 PM

Are there any Canned drill cycles in your program ? Some will turn OFF the CV as part of the canned cycle but FAIL to turn it back on when done.

Just a thought, (;-) TP

Title: Re: CV Mode turns off by its self
Post by: derekbpcnc on June 03, 2012, 04:46:25 AM

I've had this happen - often.

Instead of a restart, I edit the program headder when it happens to add G64.

Bit of a pain, but I live with it ;-)

ATB

Title: Re: CV Mode turns off by its self
Post by: Aeroshade on June 13, 2012, 07:06:13 PM

Worked GREAT.. Thanks!! :)

Title: Re: CV Mode turns off by its self
Post by: TOTALLYRC on June 19, 2012, 07:05:39 PM

The funny thing I see when this happens is that the check box on the general config page gets unchecked as well.
I have just added a G64 to the beginning of all my programs that use G64.