Machsupport Forum

Mach Discussion => Brains Development => Topic started by: lightntrax on May 30, 2012, 03:05:38 AM

Title: Check the hole was drilled
Post by: lightntrax on May 30, 2012, 03:05:38 AM

I am thinking about using an optical sensor to tell my machine that the hole was drilled.  I am doing a continuous drill system with a small drill bit.  I would like to know that the hole was drill and the bit didnt break off in the hole.  This would step through the subroutine in my G Code.  Is this possible?

Thanks.  Eddy 

Title: Re: Check the hole was drilled
Post by: stirling on May 30, 2012, 03:22:01 AM

Eddy - please do not cross post - especially numerous times. you already have an active thread for this here http://www.machsupport.com/forum/index.php/topic,20499.msg142371.html#msg142371 (http://www.machsupport.com/forum/index.php/topic,20499.msg142371.html#msg142371)