Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: rnr107 on March 20, 2012, 07:12:36 AM

Title: Anybody tryed that before?
Post by: rnr107 on March 20, 2012, 07:12:36 AM

Hi,
I am trying to enbed my PC running Mach3 into my CNC system.
And doing some researches I came across the Zotac NANO-VD01 mini PC.
This is nice and small...

I was jusf wondering if anybody tryed intalling Mach3 on one of these?  Would it have enough power/resources to run Mach3 ?
(I know there is not LPT port on it, but I am using a Eth-SmoothStepper board)

Ta,
RNR

Title: Re: Anybody tryed that before?
Post by: Hood on March 20, 2012, 07:44:13 AM

I use Via Pico motherboards in my Computurn Lathe and Beaver mill and they work great. 1Gig embedded CPU, 1 Gig DDR and all in a small 100mm x 72mm size :-)
I use the ESS on the lathe and the SS on the mill.
Hood

Title: Re: Anybody tryed that before?
Post by: rnr107 on March 20, 2012, 08:00:35 AM

Thanks for the reply mate!    ;)