Machsupport Forum

Mach Discussion => FAQs => Topic started by: customcnc on January 12, 2012, 05:08:33 PM

Title: Mach 3 setup
Post by: customcnc on January 12, 2012, 05:08:33 PM

Hello, I am upgrading from Mach 2 to Mach 3 and I do seem to be abel to get Mach 3 up and running right.  I have the motors turning and set the steps up and seem to have axis moving, but when I load job and try and cut, it seem that the x axis want to start job and then start to run off table.  Could anyone help me with this?  My Mach 2 ran perfect.  Any answers.  Thanks

Title: Re: Mach 3 setup
Post by: RICH on January 12, 2012, 06:19:14 PM

Seems like you are missing steps. Lower the acceleration and velocity. OR make sure the cutter is located correctly for the program to be run

RICH