Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: comet on January 01, 2012, 08:06:31 AM

Title: adding a second mpg
Post by: comet on January 01, 2012, 08:06:31 AM

Hi,I want to have 2 mpg'd on my 3 axis mill,mpg1 will switch between Y & Z axis using 186 and 187 oems, but I want mpg to be on x only I dont really want to use 281 toggle axis for that.Any Idea?
  regards
   Tony

Title: Re: adding a second mpg
Post by: RICH on January 01, 2012, 08:16:06 AM

Use dedicated pins for the X mpg?

RICH

Title: Re: adding a second mpg
Post by: comet on January 01, 2012, 08:18:46 AM

not really with you there Rich? dedicated pins? Im using a pci pp card to operate the mpg set up

Title: Re: adding a second mpg
Post by: comet on January 01, 2012, 11:19:27 AM

how do I dedicate the pins?

Title: Re: adding a second mpg
Post by: RICH on January 01, 2012, 03:32:58 PM

I use two MPG's and in Config>Ports & Pins> Encoder/MPG's....MPG#1 & #2 are enabled, use the same port but use 4 different
pin assignments for the A & B Pin#.

RICH