Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: Scott Pancheau on December 28, 2011, 10:09:41 AM

Title: USB MPG problem
Post by: Scott Pancheau on December 28, 2011, 10:09:41 AM

Looking for help with China made Mach only pendant. Uses USB and Comm ports to connect. I believe I have followed the instructions to install the pendant. All functions work as they should with the exception being axis selection. I have to select the axis I want the MPG to  operated on Mach screen. Mach does not seem to recognize the select buttons on the pendant. Any ideas ? Thanks


Scott

Title: Re: USB MPG problem
Post by: Scott Pancheau on December 30, 2011, 09:43:20 AM

Found problem to be that I did not have the Macro pump installed.

Title: Re: USB MPG problem
Post by: bondeoca on April 02, 2012, 03:03:22 PM

Is this a diycnc mpg. If so I have one also and I am trying to change the step settings so I can step down to 0.001" .
Right now the smallest increment is 0.01 " Do you know how to change the setting s for this .

Thanks Rick