Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Fred_evans on December 22, 2011, 03:45:34 AM

Title: after the crash - episode 2
Post by: Fred_evans on December 22, 2011, 03:45:34 AM

I am not going to reinstall because I am scared of loosing the calibrations

Can I re install and not have to recalibrate everythinh again

regards fred evans

Title: Re: after the crash - episode 2
Post by: Tweakie.CNC on December 22, 2011, 08:28:16 AM

Hi Fred,

All of your previous set-up will be stored in the .xml file (named as the profile you are using .xml) and located in you Mach3 folder. Copy this file, save it somewhere safe (memory stick is good), then use it to over - right the new .xml file after the re-install. It is also wise to keep a copy of your license file and screen set, just in case everything gets deleted.

Tweakie.