Machsupport Forum
Third party software and hardware support forums. => Modbus => Topic started by: machpirate on December 17, 2011, 03:40:25 PM
-
Hello,
I don´t know where to start from here, because the index is mapped properly from digispeed to Input4 on modIO and it blinks friendly. ;D The input is mapped under Inputs ->
Index to Port 0 and pin 4, BUT mach3 shows a rpm between 25 and 39 and it is going up and down.
I figured that it is necessary to readout the rpm register 1057, but where to setup such a readout, or map the readout to rpm DRO.
all the best
seth