Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jimthefish on December 16, 2011, 06:14:38 AM

Title: Connecting a printer
Post by: jimthefish on December 16, 2011, 06:14:38 AM

Hi I'm using a 10 year old Dell computer to run my Mach3 software through a standard printer port (25pin). Before I connect a printer into the system via a usb port can someone advise that this will not effect my connection between the computer and my CNC Mill. E.G Mach will not get confused when I try to print out a copy of any programs. Don't want to upset my set up which is running perfectly.

Title: Re: Connecting a printer
Post by: RICH on December 16, 2011, 06:41:38 AM

I have connected my printer and other things to the PC  which runs my machines and never had a problem.
Using them when actually having  Mach control a program should not be done.
Your pc may behave differently.
RICH

Title: Re: Connecting a printer
Post by: Picengraver on December 16, 2011, 10:27:02 AM

Since it is a USB printer, can't you just "pull the plug" on the USB cable to the printer unless printing?  Better safe than ruin a long job.  Windows frequently does strange, unexpected things.

Regards,
John Champlain
www.picengrave.com

Title: Re: Connecting a printer
Post by: Tweakie.CNC on December 18, 2011, 11:08:00 AM

Hi Jim,

If your CNC is all running OK then don't risk the printer connection.
Why not use a memory stick or something similar to transfer a copy of the program to another computer which is connected to a printer ??

Tweakie.

nb. If you don't have another computer - It's Christmas time  ;D