Machsupport Forum

Mach Discussion => Mach Screens => Topic started by: jonny quest on November 25, 2011, 08:10:36 AM

Title: fusioncnc "fanic' screen info needed
Post by: jonny quest on November 25, 2011, 08:10:36 AM

Zealous, member here and owner of fusioncnc has a very nice fanuc screen  clone that he calls "fanic"

I tried contacting him via pm on here and email through his site with no response.

Anyone have that screen? Bug free? I'd like to purchase it!

Title: Re: fusioncnc "fanic' screen info needed
Post by: electromech31 on April 17, 2013, 01:52:33 PM

Have you heard anything about the fanic screen.  I run a fanuc control at work so be really nice to come home and run the same thing.

Sent from my SCH-R760 using Tapatalk 2

Title: Re: fusioncnc "fanic' screen info needed
Post by: Chaoticone on April 17, 2013, 01:58:45 PM

This is the thread where it started.

http://www.machsupport.com/forum/index.php/topic,6204.msg44966.html#msg44966

Brett

Title: Re: fusioncnc "fanic' screen info needed
Post by: BR549 on April 18, 2013, 11:29:45 AM

HIYA Bret did you ever finish the screenset "Fanic" ? 

Does it have the fulll Fanuc set of pages or just the main screen?

Just a thought, (;-) TP

Title: Re: fusioncnc "fanic' screen info needed
Post by: Chaoticone on April 18, 2013, 11:59:14 AM

I would have to open it up and see what works and what doesn't.  It was all working at one time but there were some changes made in the way CB was handled that broke most of it but think it has been sorted since then.  It is only the main screen now but I had plans to add other pages.  The other reason I stopped was Jason wanted to do it in Flash and sell it.  I may well pick this back up soon though.  Any suggestions if I do?

Brett

Title: Re: fusioncnc "fanic' screen info needed
Post by: BR549 on April 18, 2013, 12:07:02 PM

I have worked on a lot of screensets in the past that mimicked other controllers. It was very usefull to those that were switching over to Mach3 to have a familar screen to work from.

There are MANY retired/retiring machinist out there that grew up Fanuc.

Just a thought, (;-) TP

Title: Re: fusioncnc "fanic' screen info needed
Post by: Chaoticone on April 18, 2013, 12:11:18 PM

I agree TP, was the only reason I started it myself.

Brett