Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: borrisl on January 31, 2006, 07:29:25 PM

Title: No toolpath display after 1.90 installation
Post by: borrisl on January 31, 2006, 07:29:25 PM

After installing 1.90, non of my toolpaths display in the graphics box.  The green, toolpath trace shows up during machining, but nothing apears from regen toolpath.  Anything I am doing wrong?

Title: Re: No toolpath display after 1.90 installation
Post by: Art on January 31, 2006, 07:58:19 PM

Hi:

 Hmm, check the toolpath config. Did the coloutrs get set to black or something?

Title: Re: No toolpath display after 1.90 installation
Post by: borrisl on January 31, 2006, 09:02:14 PM

Nope.

Title: Re: No toolpath display after 1.90 installation
Post by: Art on January 31, 2006, 09:22:26 PM

Is the file a series of G81'sd only? They may not display much other than red lines to get there. Load the roadrunner, does it display??

 Art

Title: Re: No toolpath display after 1.90 installation
Post by: borrisl on January 31, 2006, 09:39:58 PM

No display with road runner.  It's naked!!!!

Title: Re: No toolpath display after 1.90 installation
Post by: borrisl on February 01, 2006, 12:14:41 AM

Now I have 1.84 with no toolpath display.  Wonder if I should employ the uninstall, clean, and reinstall option?

Title: Re: No toolpath display after 1.90 installation
Post by: Brian Barker on February 01, 2006, 05:45:03 AM

Try to double click on the graphic screen. This will tell it to redraw...

Title: Re: No toolpath display after 1.90 installation
Post by: borrisl on February 01, 2006, 11:46:23 AM

I don't know what the problem was, but I uninstalled, deleted the Mach3 folder, deleted anything I could find in the registry, and then reinstalled.  Now, life is grand. 

Title: Re: No toolpath display after 1.90 installation
Post by: John S on February 01, 2006, 03:45:37 PM

Black hole ??

John s.