Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: lew on December 20, 2006, 03:00:35 PM

Title: Wire gauge
Post by: lew on December 20, 2006, 03:00:35 PM
Another question.
I'm using Gecko's and Mach3. Just now building the system.
Wondering what recommendations for wire size?
I'm using 12awg. from the torroid to the capacitors but don't think I need or can use this size for power to the gecko's and out to the stepper's.
What should I be using from the gecko's to the steppers and what should be used from the power supply to the power and ground on the gecko's?
Thanks in advance.
Title: Re: Wire gauge
Post by: Graham Waterworth on December 20, 2006, 06:58:49 PM
As long as you know the voltage and the maximum power required you can work out the cable size.

formula :- watts/volts = amps

So 1000/240=4.16 Amps

Or 1000/120=8.33 Amps

16 AWG will take approx 15 Amps
21 AWG will take approx 2.5 Amps

All you need to do is pick a cable of this rating or higher.

The table gives a guide as to the AWG to MM2 conversion

Graham.
Title: Re: Wire gauge
Post by: Chaoticone on December 20, 2006, 07:30:03 PM
Good job Graham! Ohms laws anyone?  ;D
Title: Re: Wire gauge
Post by: lew on December 20, 2006, 08:18:25 PM
Thanks a bunch for the information.