Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: hacker77 on October 25, 2011, 11:38:16 AM

Title: How do you change Programs in MACH 3 File Menu
Post by: hacker77 on October 25, 2011, 11:38:16 AM

Ok this has probably been answered a million times ,but here goes.  When opening Mach 3 and scrolling over "File" a list of programs appear,  (Sheetcam,V Carve Pro,Lazycam, etc.)  How does one ADD or REMOVE the programs in this list?     Thanks   Rich

Title: Re: How do you change Programs in MACH 3 File Menu
Post by: Hood on October 25, 2011, 02:07:53 PM

Uninstall the programmes in question I would think.
Hood

Title: Re: How do you change Programs in MACH 3 File Menu
Post by: hacker77 on October 26, 2011, 07:26:47 AM

Thanks, Hood I try that and they stayed .I thought it might be customized to your taste.
Thanks Rich

Title: Re: How do you change Programs in MACH 3 File Menu
Post by: Hood on October 26, 2011, 07:55:44 AM

Dont know then probably have to email support and see if they can give you a clue how to do it, may mean editing the registry.
Hood

Title: Re: How do you change Programs in MACH 3 File Menu
Post by: RICH on October 30, 2011, 05:30:25 AM

I installed a trial copy of Sheetcam TNG and it created a listing under the file tab.
Once the program was uninstalled the Mach listing went away.
So uninstall the programs like Hood said and their listings should go away.

RICH