Machsupport Forum
Mach Discussion => VB and the development of wizards => Topic started by: zarzul on December 19, 2006, 10:35:40 AM
-
I have done a couple of turn wizards and have some ideas for a couple more.
I was thinking of an ID groove, this would be very handy. I have a couple of occassions where I would use this.
The other one is a end groove, I have been doing this manually. I use it for placing an o-ring groove on the end of my underwater containers.
I haven't gotten much feedback on the other wizards I have already done, but I have used the taper ones multiple times they work well when you need to run the taper right up to a face or you can't overshoot into the X.
I think I will start on the end groove.