Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Riley on September 08, 2011, 10:35:39 AM

Title: wizard tool select trouble
Post by: Riley on September 08, 2011, 10:35:39 AM

On the "tool properties" page when I click on the "select tool from table" button nothing happens anymore....always used to work. The machine that is having the problem has never been on any network at all. Not sure what went wrong....expect I clicked on something but for the life of me I can't get it to bring up tool table when I select that button. I still can bring up the table through >config>tooltable...

Title: Re: wizard tool select trouble
Post by: Riley on September 14, 2011, 07:57:17 PM

The wizard I'm having trouble with is the Newfangled "A Suite of Handy Wizards". It just wont let me select from my tool list. Not that I can't enter it myself but it worries me that something else may fail....It is a standalone machine so I really dont think it caught a virus. Any ideas?

Title: Re: wizard tool select trouble
Post by: RICH on September 14, 2011, 08:06:21 PM

NFS is a suite and requires a license.
RICH

Title: Re: wizard tool select trouble
Post by: Riley on September 14, 2011, 08:27:55 PM

I have it...been using it for about ten months. I have not changed anything that I know of other than a bunch of end mills.

Title: Re: wizard tool select trouble
Post by: Hood on September 14, 2011, 08:35:40 PM

You would be best going to the NFS part of the forum as Ron should be able to help you out. Sounds to me like eitherthe script in the button is corrupt or the tooltable is missing.
Heres a link to the correct part of the forum for asking about it  http://www.machsupport.com/forum/index.php/board,3.0.html

Hood

Title: Re: wizard tool select trouble
Post by: Riley on September 14, 2011, 08:48:38 PM

Thank you, will check it out.