Machsupport Forum

Third party software and hardware support forums. => Modbus => Topic started by: albert on July 02, 2011, 08:57:02 AM

Title: modbus TCP
Post by: albert on July 02, 2011, 08:57:02 AM

Hi anyone know how I can send x-axis through Modbus TCP Mach3 in brain or macropump? or some such place where I can contact?

 greetings, Albert

Title: Re: modbus TCP
Post by: poppabear on July 02, 2011, 09:38:12 AM

for what? to send to an LCD? to send to a PLC? what?

Title: Re: modbus TCP
Post by: albert on July 02, 2011, 09:44:42 AM

is to send an LCD display and power the X-axis

Albert

Title: Re: modbus TCP
Post by: poppabear on July 05, 2011, 11:01:22 AM

LCD yes,
Axis, no, TCP is fast enough, but the loop time of m3 is 10hrtz to slow for motion.

Title: Re: modbus TCP
Post by: albert on July 08, 2011, 12:47:45 PM

hello, I do not understand?, you can not send information of the axes or "dro" Mach3 to a 4x20 LCD connected to the pokey56 through the TCP? must be done through macropump? can ayudarne?

 Thanks, Albert