Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: chuckels on December 04, 2006, 02:51:40 AM
-
The instructions for loading screensets says " To use, select layout/load screenset and select the name of the set you downloaded."
where is the layout/load option in mach3?
chuck
-
View tab then load screens then a window will pop up, you will find the screensets in the Mach folder.
Hood
-
thanks, Hood
I installed all the screens in the dnload area the only ones that show in load screens are the lset (turn screens)??
chuck
-
Have a look at the file types in the bottom of the browse window, set this to .set and you should see the others. If you dont then possibly you downloaded them to a different folder other than the Mach3.
Hood
-
Hood,
I downloaded your zip file, u zipped it dropped to folder of the buttons and the file in mach3 folder, i copied a mach3 mill in loader to TouchMill and then started touch mill, went to View ,screen loader, picked mpgcarbon.set. when it opened it was all jazed up. What did i do wrong. Heian
-
Have a look on general config page and make sure you dont have Auto Screen Enlarge checked.
I had a problem with a background on one of the pages in one of the earlier versions of screen4, it made the background huge and I cant get rid of it unless I redo the whole page. As I dont use Auto Enlarge I dont really have the inclination to redo it but maybe one day ;)
Hood
-
Hood,
No its not the auto enlarge. It seems like a lot of the buttons are missing. should i have taken all the buttons an loaded them in mach3 main file , I left them in the folder called hoodbuttons in the main mach folder. If i mouse click along the bottom the screen, the screens change even though i cant see any buttons.
Best, Heian
-
I think you should put the folder called hoodbuttons and place it in your bitmap folder.
Brett
-
Thanks Brett,
It works now.
Best Heian
-
Good deal. :)
Brett