Machsupport Forum

Third party software and hardware support forums. => Galil => Topic started by: bubba on April 14, 2011, 07:04:28 PM

Title: what galil card works best
Post by: bubba on April 14, 2011, 07:04:28 PM

Hi Guys,

Has been a while since I was here.
I was going to switch to Mach3 in 2008 but could not stop production to do the upgrade.

Anyway I am at a point where I can actually do the upgrade.
What is the best ( most compatible Galil card to use these days?
The Galil card I still have is the 1742 isa bus card.

Since I want to upgrade the computer ISA is out.

I will probably stick with the steppers (since I already have them and they work)
I will run 4 axis, and handwheel pendant.

What should I buy!

Thanks,
Joe

Title: Re: what galil card works best
Post by: smurph on May 11, 2011, 08:43:51 PM

I like the Econo Ethernet controllers.  21x3 and 41x3.

Steve