Machsupport Forum

General CNC Chat => Show"N"Tell ( Your Machines) => Topic started by: S3MIH3MI on April 12, 2011, 08:05:52 PM

Title: One handed wireless Mach3 Controller
Post by: S3MIH3MI on April 12, 2011, 08:05:52 PM

Not sure if this is the right place to post this but Thought I would share this...............

I have used a few different controllers for my PS3.
I have a couple in a box I no longer use.
I took the Fragnstein out this morning and decided to set it up for Mach3.
It is wireless and fully configurable. I programmed it on my main PC and then
down loaded it to the unit. The settings can be saved as well.
Then you just plug it in the PC running Mach3 and your good to go.
Both the mouse and the nunchuck have an auto sleep mode, which I find nice
because once it is setup and running G code you don't need manual action
and you won't accidently bump a key.

http://home.cogeco.ca/~fileme/vids/Fragnstein.wmv (http://home.cogeco.ca/~fileme/vids/Fragnstein.wmv)

Title: Re: One handed wireless Mach3 Controller
Post by: Tweakie.CNC on April 13, 2011, 02:38:14 AM

Thank you for posting the information.

Tweakie.