Machsupport Forum

Mach Discussion => Feature Requests => Topic started by: JungleStreetRecords on March 27, 2011, 11:59:16 PM

Title: Disable Emergency Mode
Post by: JungleStreetRecords on March 27, 2011, 11:59:16 PM

I think an emergency mode should be an elective setting in the software, so if Mach3 becomes intelligent to know if a CNC is operating out of control, it can automatically End the Program when things go out of sync.

What is emergency mode anyway?

Title: Re: Disable Emergency Mode
Post by: andrewm on March 30, 2011, 03:36:43 PM

You should check this out, it does something similar to what you are describing.

http://romaxxcnc.com/encoderinterface.html