Machsupport Forum

Third party software and hardware support forums. => Galil => Topic started by: Shivu on December 29, 2010, 02:09:19 AM

Title: Problem in Motor Tuning
Post by: Shivu on December 29, 2010, 02:09:19 AM

Hi all,

I am trying to change the value of step per in the motor tuning, when i changed the value of step per to any value the Graph disappears and the velocity will become ZERO. and i am not able to enter the velocity the velocity will become ZERO even if  enter the new velocity value.

Any solutions?

Shivu.

Title: Re: Problem in Motor Tuning
Post by: smurph on December 29, 2010, 08:25:10 PM

I'm not sure on this one.  Some parameter is not right.  You might post this question to the General section and get more responses.

Steve

Title: Re: Problem in Motor Tuning
Post by: HighOctane on December 29, 2010, 10:13:54 PM

Just in case you ran into the same problem as I did... Go to Config > Ports & Pins > Motor Outputs. Make sure the axes you want to run are enabled with the check mark. Last week I was unable to use the Motor Tuning menu in mach and the graph was not working right either... It was because I had not enabled the axes in the Motor Outputs tab.

Josh G.