Machsupport Forum

General CNC Chat => Show"N"Tell ( What you have made with your CNC machine.) => Topic started by: cncorbust on November 06, 2010, 09:20:49 PM

Title: wood carving Golden Retriever (anja)
Post by: cncorbust on November 06, 2010, 09:20:49 PM
This is a CNC carving 7" by 7" Routed out in light Oak. The colour was a pretty good match for the subject colour.
Made from a grey scale image much modified to make sure that the depth of cut was consistent with how deep or high the surface
should be to properly represent the relief.

It was an early attempt to use my newly fabricated machine which at the time had  utiility 1/2" by 20 lead screws.

Mike
Title: Re: wood carving Golden Retriever (anja)
Post by: TramAlot on November 19, 2010, 12:02:34 AM
good looking dog  :)
Title: Re: wood carving Golden Retriever (anja)
Post by: Tweakie.CNC on November 19, 2010, 03:32:13 AM
Nice work Mike.

Tweakie.
Title: Re: wood carving Golden Retriever (anja)
Post by: budman68 on November 19, 2010, 07:55:03 AM
Very nice Mike, what software did you use?

Dave
Title: Re: wood carving Golden Retriever (anja)
Post by: cncorbust on November 19, 2010, 09:27:31 AM
I used DesckCNC it has a basic greyscale/raster conversion to Gcode. I use DeskCNC for most of my DXF to Gcode  (2.5D) operations.

Mike