Machsupport Forum
Mach Discussion => VB and the development of wizards => Topic started by: ROCKO86 on October 22, 2010, 08:43:07 AM
-
Hello!
Is there a way that I can use Mach3 Pulsing Engine?
I mean, as you may know, there are io.dll or inpout32.dll. With these I can control the parallel port, but they are not precise at all.
I'm using WinXP SP3 and interested in any solution (especially Delphi, but I would be very thankful for any visual basic, visual c++, visual c# ideas).
Thank you very much!
Zoltan Szabo