Machsupport Forum

Mach Discussion => Feature Requests => Topic started by: ex apprentice on September 20, 2010, 02:15:14 PM

Title: Motor RPM
Post by: ex apprentice on September 20, 2010, 02:15:14 PM

Hi all
I am only asking, maybe it does exist somewhere, but I haven't found it yet??

A feature in the Motor tuning section that tells you the motor RPM, is it a simple count thing?? based on number of steps per revolution you set
can mach calculate and then display actual (calculated) RPM in a window on the Motor tuning page, might come in handy

Thank you

Title: Re: Motor RPM
Post by: Dan13 on September 21, 2010, 03:25:11 AM

I assume you're wanting this for the axes motors. You could easily do this in a brain or a macropump if you found a way to extract the feedrate of each axis from the blended feed DRO ;) Not so easy I think.

Dan