Machsupport Forum

Third party software and hardware support forums. => Galil => Topic started by: MAT on June 29, 2010, 08:19:24 AM

Title: Galil dmc1425 doGmove issue
Post by: MAT on June 29, 2010, 08:19:24 AM

I use a dmc1425 with servo motor for a xy table. I try to use MACH3 and the plug-in (lastest version) to control this table . But, the plug-in doesn't work with 1425 properly. In fact, just the continuous jog mode work. My representative try plug-in with a dmc2123 and it work properly. With same settings, his 1425 does't work. We ask to Galil the difference between this two type of controller and the most important is the size of buffer. The 2123 has 511 lines and the 1425 only 255. I check the galilcontrol.cpp file in sdk folder and I think that's why the plug-in does't work with 1425. Unfortunately, I don't have visual studio to compile code.

Thanks a lot

Title: Re: Galil dmc1425 doGmove issue
Post by: MAT on June 29, 2010, 08:28:58 AM

Moreover, I check in galildebug file. When we ask a G move in programmed mode, no command was save in debug file. It is for this reason than we search for buffer size problem.

MAT

Title: Re: Galil dmc1425 doGmove issue
Post by: smurph on July 30, 2010, 02:03:38 AM

This should be fixed now.