Machsupport Forum

G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: mikem on June 23, 2010, 01:42:22 AM

Title: Opening LC in plasma mode
Post by: mikem on June 23, 2010, 01:42:22 AM

Hello,

I am using LazyCAM to convert DXF's in plasma mode. I make some mods in LC and save
the project as a .lcam file. If I exit LC and come back to it when I open the .lcam project
is defaults to mill mode. I can work around this by opening dxf in plasma, closing then
opening .lcam file but it is a pain.

Any comments/advice?

mike

Title: Re: Opening LC in plasma mode
Post by: RICH on June 23, 2010, 09:14:31 AM

Mike,
I don't remember anything posted about it and plasma is not covered in the manual.
Don't have any suggestions.
RICH