Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Darian on June 22, 2010, 03:53:48 AM
-
Hello I'm new to this and need some training wheel help please!
I'm using M3 with a C10 breakout and id like to know how i could control the speed of my spindle, the only info i have on the spindle speed controller is on the link below which has a diagram (and its in Japanese). Will the C10 do a variable Voltage/Current? into the VS,VC or CC inputs?. Also how come i cant ramp my spindle speed up past 8000rpm (not that it matters at the moment)
I can turn the spindle on and off but i have no speed controll, if any one could help that would be great and much appreciated.
http://www.lingnangroup.com/ProductInfo.aspx?ProductID=229&LevelCode=00101001
Thanks
D
-
Hi D,
Unfortunately the C10 does not have the on board variable speed control (it's the model C11 that has this). However this does not stop you varying the spindle speed using a seperate PWM / 0 - 10 Volt board for controllingl your VFD.
Tweakie.
-
Hi Thanks
Will look into it
Cheers
D