Machsupport Forum

Third party software and hardware support forums. => LazyTurn => Topic started by: Ampliflyer on April 01, 2010, 11:20:43 AM

Title: trouble importing lazyturn gcode
Post by: Ampliflyer on April 01, 2010, 11:20:43 AM
Hello I am trying to use Lazyturn for the first time and can import my

DXF drawing and seem to be able to cam the cut paths no problem and I can generate gcode.

The problem is when i try to open the .tap file in machturn I get a nasty little message saying "bad format unsigned integer line 2"

Anyone run across this one?
Title: Re: trouble importing lazyturn gcode
Post by: RICH on April 01, 2010, 11:45:48 AM
See attached
RICH
Title: Re: trouble importing lazyturn gcode
Post by: Ampliflyer on April 01, 2010, 01:14:13 PM
Rich, You ROCK! that was it...thanks-a-million!!