Machsupport Forum
Third party software and hardware support forums. => Modbus => Topic started by: stevens157 on January 23, 2010, 10:57:17 AM
-
I have one of the ModIO MP-03 pendant kits that I have built. I have all of the buttons and switches working but the one problem I have is that I have never been able to get the LED lights above the 3 middle switches or the led to the right of the cycle start button to work. All of the buttons work just not the lights. The lights for the estop, spindle, and feedrate work fine. I have tried multiple configurations and going through the ModIO manual without luck. I also don't believe it is a wiring issue since the corresponding lights on the modio board do not light up either. Any insight would really be appreciated. I am using the MP-03 plugin version 2.1.
Thanks
Mike
-
Recheck your wiring, verses the schematic and trigger the lights directly through the serial modbus test dialog.
scott
-
Wiring checks out. I am a little lost on how to manually trigger through the test dialog. How and where do I do that? Do I need to setup something in the modbus or output configuration screens?
Thanks for your help!
Mike
-
Mike, in the plugin's dialog, there is a button labeled "Help" push it and it will bring up a seperate Flash How To, window, it will go step by step for you on how to setup/use the MP-03.
scott
-
I have gone through and checked everything. It is all setup the way the help file states. On the mp-03 page I can see the state change for all of the buttons. I can also get the state to change for the Spindle, E-Stop, and FRO LED. I cannot get them to change for the Tool change, Soft Button LED A,B, or C.
-
I got the led"s for the soft buttons to work when the left switch is in positions 9 - 12. I still cannot make the light next to the lower left button come on at all.
-
??? hmmm dont know then, if you can email Peter and ask him to help you, unfortunatly, my conex of stuff from the states wont be here to my duty station for a month or more??........ sometimes a crap shoot with the army.
scott
-
Is all good. I will keep at it. I just wanted to make sure it wasn't something simple I was overlooking.
Mike
-
Is there a newer version of the plugin thatn the one I am using? I have 2.1.
-
Hi,
Scott, thanks for helping out.
Mike, can you test that the output for the LED is working? You can do this by observing the corresponding SMT LED on the ModIO board. Does it illuminate?
If not, then you need to go to the Mach3 Modbus Test page and turn the Led on through there to test if it works.
As to the plugin, the latest one I have from Scott is Ver: 2-4
Send me your email and I'll send it to you.
Cheers,
Peter.
-
Sorry Pete,
Have to wait till the connex with out "personal bulk" shipping gets here, approx, 1-2 months from now........ When it comes in, I can do live test with
the Kit I shipped via the connex, prior to leaving the states.........
Pete BTW: if you can send me an email, I am updating the MAD to v3.8 (just now adding where you can enter data directly into the dropdowns
instead of having to be forced to scroll for the number.............), I will send the new installer
scott