Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: JDolecki on September 18, 2006, 08:26:21 PM

Title: Computer shuts down on Mach 2 & 3 boot up.
Post by: JDolecki on September 18, 2006, 08:26:21 PM

My Flat panel touch screen computer now shuts down during boot up.

My compuer is a industrial flat panel computer. 500mhz running Windows 2000. I already had Mach 2/3 (Demo) on there but couldnt get it to communicate with my breakout board. So i decided to reload Mach  but now right after the Mach screen appears on the screen it flashes an error then shut my computer down. It reboots fine. but after several tries of deleating and reloading i dont know what to do.

The only thing that has changed with my computer is i using a 1gig usb flash drive to load the program from my desktop.

Any sugggestion would be helpful.

Thanks john.

P.S. the program and breakout board run fine from my laptop.

Title: Re: Computer shuts down on Mach 2 & 3 boot up.
Post by: JDolecki on September 18, 2006, 09:19:02 PM

I got it fixed. Read a post abotut the device drivers. removed them and rebooted and the issue went away.

Title: Re: Computer shuts down on Mach 2 & 3 boot up.
Post by: Brian Barker on September 19, 2006, 07:33:13 PM

Good job getting that fixed!

Title: Re: Computer shuts down on Mach 2 & 3 boot up.
Post by: cncgroup on November 12, 2016, 01:10:46 AM

John could you tell me what article you read on device drivers?  I seem to have something of your problem.

thanks bob