Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Jhtitan on December 22, 2009, 01:09:10 PM
-
not sure what the minimum system requirements are for mach3 and LazyCam but I keep getting an OpenGL error every time I try to load a drawing from lazyCam to Mach3. anyone know if I just need a graphics card or is there a setting somewhere that would fix this?
for the record its a Dell GX280 3gh CPU with 2gb RAM using the on-board Graphics.
its controlling a HobbyCNC pro driver board (don't think that matters but just in case)
Thanks
Jon
-
See if you can get an updated driver for the graphics.
Hood
-
My computer gave me the same error tonight. I'm running Mach3 3.042.035 on a ABIT BH7 1.8GHz, 2GB Ram, ATI All in Wonder 9700 Pro 128MB, with the latest video drivers. I tried to launch lazy cam from my desktop and from Mach 3 and both ways received the Gl error.
Well, in my case, Lazy Cam won't even start.....it just returns the error. I saved the crash report and will upload it tomorrow, if it will help.
Thank you,
-
I don't know folks. Never had a problem and have seen it installed on probably 15 different computers ranging from
an "old dead dog "to some high end ones. ???
RICH
-
Here is the crash file that was generated when I tried to launch Lazy Cam. I had installed Mach3 on this machine multiple times until the 035 fix the other day worked for me. Could there be a remnant from a previous install causing the conflict?
I thought I had Lazy Cam working on this machine (with this V-Card) at one time.....but it may have been the other computer i have.....hard to believe that an ATI 9700 pro with the latest drivers isn't compatible.
Looking for help.