Machsupport Forum

Third party software and hardware support forums. => Modbus => Topic started by: kdoney on October 12, 2009, 11:25:33 AM

Title: Modbus Function Code 43/13
Post by: kdoney on October 12, 2009, 11:25:33 AM

Does the modbus/tcp on mach3 allow the use of function code 13 or 43/13? I was about to write a slave and wondered if I could just use CANopen to access mach3's data.

Title: Re: Modbus Function Code 43/13
Post by: Peter Homann on October 13, 2009, 07:32:38 PM

Hi,

My understanding is that the answer is no. Mach3 only used the basic Modbus commands.

Cheers,

Peter.