Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jguillen on August 31, 2009, 11:44:42 PM

Title: Alternative to Smooth Stepper?
Post by: jguillen on August 31, 2009, 11:44:42 PM

Hello All,

I want to use my laptop to run my mill.  And I know that many have had success with the Smooth Stepper board.  I need to be able to use the back lash comp with in the software.  Since the smooth stepper currently can not use this function, does anyone know of a similar board that does?.  Thank you in advance.

Jose.

Title: Re: Alternative to Smooth Stepper?
Post by: RICH on September 01, 2009, 06:27:19 AM

Jose,
I am not aware of any. I made a promise that i wouldn't complain anymore about the lack of backlash with the SS.
Enough said. Don't buy it if you realy need backlash comp!
RICH