Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: morgan on August 31, 2009, 09:37:35 PM

Title: history errors
Post by: morgan on August 31, 2009, 09:37:35 PM

 I keep getting an error that says    "  Radius to end of arc differs from radius to start of line "
I'm using vectrics Aspire and Vectrics pro 6 and both get the same error is there a setting in Mach 2/3 that might have got changed ?

Title: Re: history errors
Post by: ger21 on August 31, 2009, 10:00:43 PM

IJ mode in general config.

Title: Re: history errors
Post by: morgan on August 31, 2009, 11:02:54 PM

thanks ger21 I'll give it a try tomorrow 

Title: Re: history errors
Post by: morgan on September 01, 2009, 04:13:25 PM

Ger21 thanks I changed the setting of the iJ mode and it works great  your a life saver

thanks again