Machsupport Forum

Mach Discussion => FAQs => Topic started by: tipit on July 06, 2009, 02:19:40 AM

Title: Automatic Z control family
Post by: tipit on July 06, 2009, 02:19:40 AM

Hi, I have been reading through Using Mach Mill user's guide to installation, (configuration and operation) and in the section 6.2.17 I found this interesting control but in my Mach3 I don't see it, anybody knows where can I locate this. I am using Mach version 3.042.020
Thank you

Title: Re: Automatic Z control family
Post by: Hood on July 13, 2009, 09:52:05 AM

Look at the multi pass wizard.
Hood